Manual J load calculation
Right-sized tonnage so the system dehumidifies instead of short-cycling.
RioTech Services LLC • License TACLA164237R
Air Conditioning Installation & Replacement
A system installed correctly in the Valley will outlive one installed fast by several years. We size equipment off an actual Manual J load calculation — square footage, glazing, insulation, orientation and infiltration — instead of matching whatever tonnage happened to be there before.
Installations include the parts that quietly decide whether you like your new system: a properly sized and sealed duct system, a correct line-set evacuation, and a verified refrigerant charge at commissioning.
What’s included
Equipment selection
Ruud, YORK and KeepRite systems matched to your budget and efficiency target.
Duct evaluation & repair
Leaky or undersized duct gets corrected before new equipment goes on it.
Full changeout
Condenser, air handler or furnace, line set, pad, disconnect and drain.
Commissioning
Vacuum to spec, weighed-in charge, airflow verification, documented readings.
Warranty registration
We register manufacturer warranty in your name so coverage actually applies.
Signs you need this service
- System is 15+ years old and repairs are getting frequent
- Your unit still runs R-22 refrigerant
- Some rooms never get cool no matter what the thermostat says
- Humidity stays high indoors even when the AC runs constantly
- Repair estimate is approaching a third of replacement cost
- Utility bills climb every summer despite maintenance
How the job runs
- Step 1
In-home assessment
We measure, inspect ductwork, and run the load calculation.
- Step 2
Options quote
Two or three equipment tiers with efficiency and cost laid out plainly.
- Step 3
Install day
Most residential changeouts finish in one day with floors and doorways protected.
- Step 4
Commission & walk through
Verified readings, thermostat setup, and filter/maintenance guidance.
How we price it
Installation is quoted as one all-in number covering equipment, materials, labor, permits and haul-away. No line-item surprises at the end. Financing questions are welcome — call and we'll walk through what's available.
BUILT ON INTEGRITY. DRIVEN BY EXCELLENCE.
RioTech Services LLC is committed to delivering honest service and reliable performance on every single call.
Experienced Technicians
Mastery in commercial cooling, freezers, and complex HVAC systems.
Licensed & Insured
State licensed TACLA164237R for your complete peace of mind.
Quality Parts & Equipment
We install and service Ruud, KeepRite, YORK and Heatcraft equipment.
Satisfaction Guaranteed
Fast, dependable results backed by honest, upfront pricing.
AC Installation FAQs
- What SEER should I buy in South Texas?
- With RGV cooling loads, the efficiency upgrade pays back faster here than almost anywhere else in the country. Most homeowners land on a high-efficiency single-stage or two-stage system; we'll show the actual runtime math for your house.
- How long does a replacement take?
- A straight residential changeout is typically one day. Jobs involving duct replacement or new line sets can run two.
- Do you handle commercial rooftop replacements?
- Yes — package unit changeouts, curb adapters and crane setups for retail and light industrial buildings across the Valley.